BOULDER DAM COLORADO RIVER PLAQUE | ||
| vanskyock24's loves1663 of 5185 |  |  |
vanskyock24 loves this.
Blackshiep1 loves this.
walksoftly loves this.
trunkman loves this.
DrFluffy loves this.
JSmed likes this.
packrat-place loves this.
blunderbuss2 loves this.Create a Show & TellReport as inappropriate
Posted 11 years ago
Tinkerbell50
(2 items)
This is a small metal plaque attached to a very heavy piece of steel that is 6 1/2" tall x 4 " w at base & 3 " w at top I don't know much else about it. The small plate in center says Boulder Dam Colorado River
Help us close this case. Add your knowledge below.
Create an account or login in order to post a comment.
Hope it didn't weaken the dam when somebody nicked that!
That's a cool dam plaque! :)
Building Boulder (Hoover) Dam
3-inch-diameter pins Used in Penstocks in Lieu of Rivets
Placing the 12-foot long sections, some weighing 185 tons and others 135 tons, into the plugged diversion tunnels along with smaller penstocks in their lined tunnels was another major challenge. A 250-ton-capacity cableway was built which swung the pipe section over the canyon and lowered it with 10 cables coming from the cablecar. The largest sections were locked together with 3-inch-diameter pins; smaller sections were joined with hot-rivets. The workers found it hard work to drive the 3-inch diameter pins into their locking holes because of the great size.
I have only seen about 4 of the rivets with the plaque. Also I believe they were presentation pieces, instead of being purchase. They weight right at 8 lb. each.
Taken from: http://www.romanconcrete.com/docs/hooverdam/hooverdam.htm
There is a picture of one of the rivets, at the Dam part of the tour. You can see it at the link below.
http://historyofseth.blogspot.com/2007/03/techready4-and-surfaces-2007.html
I have the same medallion, without the chunk of steel.